Hy cquante,

I found a bug while allocating signals on the robot.
When you assign signals via the kide function and the robot motors are not turned off, the kide goes into a loop and you have to close kide to restore the connection.
Is it possible to check the status of the motors before sending the signal assignments and requesting to shut down the motor?

And i found a Small exception: When you open a read-only file and try to save it the exception error comes up.

Zitat von Mr.T im Beitrag #1

---

Hy cquante,

I found a bug while allocating signals on the robot.
When you assign signals via the kide function and the robot motors are not turned off, the kide goes into a loop and you have to close kide to restore the connection.
Is it possible to check the status of the motors before sending the signal assignments and requesting to shut down the motor?

And i found a Small exception: When you open a read-only file and try to save it the exception error comes up.

---